How to Simulate Verilog codes using VCS and Verdi - Video

How to Simulate Verilog codes using VCS and Verdi - Video

    • Related Articles

    • Command to Run VCS-Verdi

      While running the VCS command, enable a new switch -kdb (Knowledge Database) to enable Verdi GUI. Before running the simulation and view waveforms, user need to create *.fsdb file. This file contains the simulation data in it. This is created using ...
    • Launching of VCS and Verdi

      VCS To invoke VCS, use below command ⦁ vcs -full64 {file_name} Note: If you don’t have VCS licence access – please check your admin which tool access you have. Admin will help you how to invoke Synopsys Tools. Verdi To invoke Verdi, Use below command ...
    • Accessing vnc_server using vnc viewer

      How to Access vnc_server Step-1. We need to install tigervnc packages on your local system. To download tigervnc packages click on the link https://sourceforge.net/projects/tigervnc/ After clicking on that link page will be open like this And after ...
    • Installing of Synopsys tools

      Installing of Synopsys tools Synopsys tools are powerful, but they come with strict licensing and are usually distributed either via the official SolvNet portal or authorized partners like Eigen in India Accessing Synopsys Tools & Licenses via ...
    • Error: Can't open display:

      If you are getting any error while using the GUI - " Error: Can't open display" One of the reason is X11 forwarding is not enabled in your putty setup. Solution: Open Putty again -> Click on SSH -> X11 -> Tick mark "Enable X11 Forwarding" (as shown ...