Accessing vnc_server using vnc viewer

Accessing vnc_server using vnc viewer

How to Access vnc_server

 

Step-1. We need to install tigervnc packages on your local system.
 To download tigervnc packages click on the link

https://sourceforge.net/projects/tigervnc/

After clicking on that link page will be open like this

And after click on download. And after successfully download then you install this app on your system.
 After Completion of downloading and installing you will open the app TigerVNC. It will open like
 
 You should mention your VNC server credential (Ip-address/Hostname): Port number. For more information about hostname and Ip-address contact to the VLSI-Expert.
 
 after entering these details click on connect. After clicking on connect it will open a popup like this and prompt for the password


 after enter the password click on ok. And finally, it will open your terminal console.
 
 And go to upper left corner and click on application and system tool and terminal then it will open the UNIX terminal
 

This is vncuser terminal.

 

 

 

    • Related Articles

    • How to Access VNC_Server

      How to Access vnc_server Step-1. We need to install tigervnc packages on your local system. To download tigervnc packages click on the link https://sourceforge.net/projects/tigervnc/ After clicking on that link page will be open like this And after ...

    • Launching of WV (waveform viewer)

      WV To invoke waveform viewer, use below command >wv Note: If you don’t have WV license access – please check your admin which tool access you have. Admin will help you how to invoke Synopsys Tools

    • Putty showing error while runing wv (waveform viewer)

      When trying to run wv (waveform viwer) - getting below error Error message: Putty X11 proxy: unable to connetc to forwarded X server: Network error: Connection refused. Reason: Whenever any such error comes where keyword such as "X11 forwading", ...

    • How to Simulate Verilog codes using VCS and Verdi - Video

    • Error: Can't open display:

      If you are getting any error while using the GUI - " Error: Can't open display" One of the reason is X11 forwarding is not enabled in your putty setup. Solution: Open Putty again -> Click on SSH -> X11 -> Tick mark "Enable X11 Forwarding" (as shown ...